Where do you go on the key pad to turn off the question "cut the board" during setup.
Each time you run thru the set up questions, I don't want to answer that question.
Perry B.
Printable View
Where do you go on the key pad to turn off the question "cut the board" during setup.
Each time you run thru the set up questions, I don't want to answer that question.
Perry B.
from the main menu, 0-5-4
Now, THAT was worth the price of admission!!
Thanks so much :)
hey , if you don't ask, you never learn!!!
just clear up a question earlier, I should have "cut the board to size" not cut thru board.
I went to 0 5 4 and turn back "ON" , cut thru board", then I arrowed down and found the "prompts" and selected
"cut the board to size" and turned it off.
Perry B.
Going to do this now, that is annoying each time it pops up
Steve
I just found out that "B" and a "C" machine has 2 different prompts after you enter 0 5, "B" and the "C" are equal until you reach "4", the "C" has "prompts",
from there you can go to 1- cut thru prompt , 2-roller(ask), 3-cut to size, then it goes on 5, 6, 7, 8-lock machine.
The "B" machine matches up 4, then it states "cut thru prompt" and no other options from there, then it moves on to 5, 6, 7. (no 8)
I can not turn off "cut board to size" on the "B" machine.
any help would be great. someone else give this a try if you have a "B" and a"B" machine.
Perry.
You must be mistaken. The firmware is the same on all the machines. It is the same program.
0-5 is User Options Menu
0-5-4 is Prompts
0-5-4-1 is cut thru?
0-5-4-2 is Rollers?
0-5-4-3 is Cut to size?
Is not 0-5-4-3 the cut board to size?
0 5 4 has "cut thru prompt" , arrow down to 5 -meas. system ,etc.
My machines are B. Press 0-5-4-3 and see what you get. Maybe something is wrong with the arrow button.