Well tomarrow I will attempt to put my new z-truck on. I can hardly wait I am having carving withdraws. I am so adicted to this machine and this website it is a wealth of info. It has only been two weeks since I bought my machine and its been down for a week. That a chance I took with a demo machine. If ti hadnt been for that darn tollerance ring falling out I would still be carving. But I only paid $700 for the machine and the new z truck cost me $125 so im still under $1000 so I think im doing good. My question is what is a stamped flat wrench, is the type of wrench used on routers. If so where would I find one 12mm? Now if I could only convince my wife i need a rock chuck moving forward from here. I am so afraid my z-truck will go bad again if I dont go with the rock. I did go and purchase a new bit with a new collet just to be safe. I am trying to stay positve and look at all this as a learninng experience. Wish me luck.
Joe