Printable View
I am carving a crib board. It is primarily centerline text and lines with 1/8 holes drilled. Finished all the centerline and line cuts, machine was ready for the bit change to 1/8 to drill holes and i hit the enter button by mistake. Can i remove all the centerline cuts and leave the drilling code and carry on with the drilling?
Thanks
Yes you can.
First rename the project then delete the stuff that is done and re run the project with the holes.
If you have a problem with the holes look for the yellow restraint numbers that can pull a hole off due to it wanting to answer the restraint measurement from the edge of the board. Turn them all green by selecting attachments.
Hole problems are a common post.... Out of position.
Good Luck,
AL