small text what's better 60 deg or 90 deg
Printable View
small text what's better 60 deg or 90 deg
It's probably not the right way, but, I tell designer that I am using the 90 so it carves shallower, then I install the 60 so it doesn't carve as wide. The small letters in Dutch Oven below are 1/4 in tall. I am going to HD today, and will look for one of the narrower v bits mentioned in an earlier post this week - I think it was 22. It will be interesting to see the results.
yes a member showed the other day the nice job his 22.5 bit did ... he gets this bit from MLCS ..
Interesting: I thought the more narrow the bit the shallower it carved so I have been selecting the 60 when I use the 45 or 22 degree bit. I will need to reexamine that thought. But if you are really looking for a good selection of V-bits, MLCS does well for me. Shipping is free and selection seems good although they are all 1/4 shaft (for the narrow). Had a bad experience with a bit adapter once and bit dropped down and did some damage. Have since gone to whiteside adapters that have 6 or 8 crimp slots plus a small rubber stop band that fits in a groove. Works similar to the CW pressed on adapter with the stop rim for keeping the bit at the right depth. It is a little better than the clear plastic ring from CW. Those adapters have never failed me since I started using them. The other tip I pass on that I have learned from experience is not all fonts seem to carve with the narrow V-bits. Some fonts (not many) will not carve part of a letter when using the narrow bit if reduced to a rather small size (usually in the 1/4 in size, +or-). Look at each letter and if you don't see all of the legs of each letter it won't show up on your carve. I found that if I enlarge the size slightly it usually corrects and all is fine.
I always just set my bit to 60deg and use that bit for small lettering. If you don't go deep enough you might lose something when you sand/mop the surface.
Clint
I doubt that Home Depot had that 22.5 degree bit. I have only seen them at MLCS. I need to try one too :-)
Quote:
Originally Posted by DianMayfield
I really like your website. I have made some similar items, though not as nicely done as yours. I have never used a "sand-mop"?
Quote:
Originally Posted by cestout
I tried my hand today at carving some small lettering using the 30 degree bit from Drillman1. Came out nice. However I think my font selection could have been better. Any suggestions on what font to use?