1/2 inch spiral.
Printable View
1/2 inch spiral.
So would this make a thread design on a dowel?
CJ
Theoretically, yes it would. There are a lot of variables to consider, but as long as the design is perfect, it should make a thread design on a dowel. I have a feeling that there is going to be a lot of people testing different methods to this.
Jerry, I posted a picture and explanation of a threaded piece here: http://forum.carvewright.com/showthr...wright./page26 I guess I had forgotten where this thread was..
Ed
Yeah, I seen that Ed, thanks. Now if only we could figure a way to carve a nut to fit. It was just a thought any ways.
CJ