Printable View
Hi Guys
Got my new board sensor installed.
Now measuring board correctly.
Now i'm trying to run a project
on a 1/2 sheet of plywood.
after it asks me to load 1/8 bit
it says insert board thickness.
I enter .500 and it keeps going back
to o. won't except 1/2 either.
any thoughts.
Thx Jeff
If you have 2 boards stacked together that = 1 inch or more and it asks you to enter the board thickness you need to enter the PROJECT BOARD thickness. If I understand what you are trying to do....
Did it ask you PROJECT or BOARD? Board would be carrier and project board. By selecting PROJECT it will cut the top board on a sled only.
I had trouble understanding your question so hopefully this helps.
There is a bunch on this topic in Tips and Tricks that will help
Good Luck,
AL
Your board may be a hint under 1/2 in. thick, which could also cause problems.
Ron
Jeff, just a thought
The last skid or two of 1/2" Plywood I got was thinner than .05,
so when I stacked two layers of it together - It measured a little less than 15/16",
I had put it on a carrier board and entered the combined measured thichness to carved it.
mine won't carve a 3/8 thick , it will work down to .465
but no thiner.
Yes the board is just under .5, so I typed in .437
and away she went. Thanks guys.
Jeff
This Place is GREAT.... And no $25.00 fee....
Good Job !!!!
AL
There will be a $25 fee for accessing this forum in the future. :)Quote:
Originally Posted by Digitalwoodshop
Dont forget the $12.99 for e-shipping!Quote:
Originally Posted by www.go3d.us
Doug Fletcher
Not to mention the 2cents for thought (may actually be worth less)!