• RogerB

    There is no available content written by RogerB
  • Recent Forum Posts

    dbemus

    rnichols I believe the step up is a fault in...

    rnichols

    I believe the step up is a fault in the layout of the mpc, I will go back and check and make the correction if necessary. I think I did not set the edges to "0". Glad to see your...

    dbemus 37 Minutes Ago Go to last post
    DickB

    Thanks. I haven't kept accurate track of time. ...

    Thanks. I haven't kept accurate track of time. The front fenders weer done in 4 pieces, about 3 hours for three and an hour for one. Similar for the rear. Hood in 4 sections, 2-3 hours each. Rear...

    DickB 53 Minutes Ago Go to last post
    rnichols

    Thanks to......

    dbenus and bergerud for their help. Not completly finished yet but getting there. My first question is what would cause the step-up? I went ahead and used it with the ridge on the bottom. again...

    rnichols 2 Hours Ago Go to last post
    spalted

    LOL..... What a project! How many hours of...

    LOL..... What a project!

    How many hours of carve time are you up to so far?
    Oh wait, never mind that, how many hours of design time are you up to so far?

    Just fan freakin'tastic, it makes me...

    spalted 2 Hours Ago Go to last post
    lynnfrwd

    Is your project set up with the long carving bit?...

    Is your project set up with the long carving bit? Edit > Boards Settings > Pattern Bit > 1/8" Long Carving Bit. (Reminder to others: the 1/16" long carving bit cannot be used on the rotary jig.)

    lynnfrwd 2 Days Ago Go to last post