here is the sequence of loading so maybe you can see where I'm going wrong: following your instructions as to barely crankdown at first; then complete crankdown when asking for the bit; along with...
The machine is supposed to bob the bit into the one of the holes in the side of the carrier; not stall into the top of the side. If you use the blocks, the machine will behave as it would with a...
I have had a few successful carves with the UCB and really am pleased with it. BUT....I have brain freeze when I try to do a cut out carve, I can't get past the "finding board thickness" and of...
Recent Forum Posts
here is the sequence of loading so maybe you can...
here is the sequence of loading so maybe you can see where I'm going wrong: following your instructions as to barely crankdown at first; then complete crankdown when asking for the bit; along with...
stoneandtimber 5 Hours Ago