• Capt Bruce

    There is no available content written by Capt Bruce
  • Recent Forum Posts

    Dale

    Can you load any file to the card?

    Can you load any file to the card?

    Dale 18 Minutes Ago Go to last post
    Lincoln96

    I'm really hoping it's a bad card...

    I'm really hoping it's a bad card programmer/reader causing me grief. The STL importer worked really well once I took the time to figure out how to use it properly. It's a good tool.

    Lincoln96 53 Minutes Ago Go to last post
    DickB

    1" cutout

    First time cutting a 1" thick board.


    If I specify board thickness first, then add a cut path and drill operation through board (3/16" cutting bit), no problem. If, however, I try to...

    DickB 2 Hours Ago Go to last post
    oscarl48

    Old man sleeping face

    Here is an old man sleeping face pattern for carving (old man in the tree).

    I have owned zbrush for over two years and have no real clue on how to use it so started playing with it. Here is my...

    oscarl48 17 Hours Ago Go to last post
    oscarl48

    Good luck. I almost exclusively use the stl...

    Good luck. I almost exclusively use the stl importer and it works fairly well for me. So hope your hardware issues get resolved. You will enjoy the add-on.

    oscarl48 17 Hours Ago Go to last post