• Recent Forum Posts

    oscarl48

    There is no issue per se. In this case I believe...

    There is no issue per se. In this case I believe it was Zbrush that was causing the problem.

    Not all STL files are made the same. Some software and some software versions may not be completely...

    oscarl48 1 Hour Ago Go to last post
    fwharris

    What is the issue with 2.xx? Do you have 3.xx to...

    What is the issue with 2.xx? Do you have 3.xx to see if they work with that version and how about Basic?

    fwharris 6 Hours Ago Go to last post
    oscarl48

    Zbrush for CW patterns

    Another thread with Zbrush. Amazing software.

    I'll share patterns that I make primarily with this software package. I am currently using Zbrush 2019 and haven't updated to 2020 just for SA. The...

    oscarl48 23 Hours Ago Go to last post
    fwharris

    I would verify the thickness of the pipe, it is...

    I would verify the thickness of the pipe, it is thinner than regular litho material. According to the instructions the pattern depth should be Set the depth to .170 and height to 999 and set Bit...

    fwharris 1 Day Ago Go to last post
    bamaman315

    Rotary lamp settings

    I have tried to go a lamp project and have used the settings in the instructions, problem is it carves too deep and ends up carving all the way through the pvc pipe.
    any ideas how to correct this?

    bamaman315 1 Day Ago Go to last post
  • Recent Articles