• want2b

    There is no available content written by want2b
  • Recent Forum Posts

    Mugsowner

    I do not have 3, so I can not open your mpc,...

    I do not have 3, so I can not open your mpc, however reading what you have here makes me ask, are the lines copies of each other. I notice that copied or mirrored parts of a carve tend to stay as...

    Mugsowner 4 Hours Ago Go to last post
    Deolman

    Angle help

    OK, this is driving me crazy. If someone could help me out, I would greatly appreciate it. Please do not just fix it for me because I need to make several of these with different dimension....

    Deolman 17 Hours Ago Go to last post
    fwharris

    The picture is a bit fuzzy for me to see it...

    The picture is a bit fuzzy for me to see it good.. The most common place that the cable will break is right at the black support bracket and most times it is hard to see with out magnification or...

    fwharris 22 Hours Ago Go to last post
    cjones

    I checked the FFC cable and it appears to be OK. ...

    I checked the FFC cable and it appears to be OK. See pictures. I did notice on the board on the Z-Motor there is a burn mark by one of the other cable connectors. If you look at the one picture,...

    cjones 23 Hours Ago Go to last post
    fwharris

    Look at the ffc ribbon cable, it could be...

    Look at the ffc ribbon cable, it could be torn/cracked. This was similar to the Z stalls I was getting and got the recommendation to get the a907 upgrade.

    fwharris 1 Day Ago Go to last post