here is the sequence of loading so maybe you can see where I'm going wrong: following your instructions as to barely crankdown at first; then complete crankdown when asking for the bit; along with...
stoneandtimber 21 Hours AgoThe machine is supposed to bob the bit into the one of the holes in the side of the carrier; not stall into the top of the side. If you use the blocks, the machine will behave as it would with a...
bergerud 1 Day AgoI have had a few successful carves with the UCB and really am pleased with it. BUT....I have brain freeze when I try to do a cut out carve, I can't get past the "finding board thickness" and of...
stoneandtimber 1 Day AgoNo worries. Hope your grandson loves the carving.
oscarl48 1 Day Ago
Dan's the expert but since he has not answered...
Dan's the expert but since he has not answered I'll tell you what I do. When the bit is finding the surface of the board I hit stop and then choose #3" Jog to position" and move the carrier in the X...
Dale 12 Hours Ago