You're gonna make me end up joining Facebook yet, ain't you?.......LOL
I haven't put more than 20 seconds of thought into this yet, so I probably shouldn't even open my mouth until I look into it...
Not yet... But I am looking into using a Dewalt Brushless Router with the slap on battery eliminator 120 volt plug. I see on some CNC Pages some guy is already playing with the project and used a 15...
Digitalwoodshop 15 Hours AgoALSO since you needed to tighten the Y Belt... I would QUICKLY order some 685ZZ Bearings and make plans for some preventive maintenance and replace the two bearings inside the Y Gearbox. Having to...
Digitalwoodshop 15 Hours AgoThe machine does the board thickness routine when the carving/cutting is more than 1/2" deep. It is then that you have to jog to line up a touch hole. After the bob down the hole, the machine will...
bergerud 1 Day Ago
Thanks everyone, I sure appreciate the kind...
Thanks everyone, I sure appreciate the kind words.
spalted 7 Hours AgoI think I needed a project like this again.
Years ago I did a fair number of things like this, then I kinda drifted away from it.
This was a...