• Recent Forum Posts

    Digitalwoodshop

    Interesting.... Try turning most of the Shop...

    Interesting.... Try turning most of the Shop Lights off that are pointed at the machine. Just looking at this from the Board Sensor point of view. As in a bright light on one end of the machine...

    Digitalwoodshop 2 Hours Ago Go to last post
    want2b

    Strange cut motor sound

    Running a quick 5 min centerline carve, suddenly noticed the sound changed. Found machine running stopped in one place slightly above the board running at varying speeds. Slow and slower, no...

    want2b 1 Day Ago Go to last post
    blhutchens

    doesn’t seem there is a good answer. Some...

    doesn’t seem there is a good answer. Some reported using boot camp or parallels

    blhutchens 1 Day Ago Go to last post
    caklmk

    I need a controller, a y axis motor, and a z axis...

    I need a controller, a y axis motor, and a z axis motor. I am also needing a full set of y and z axis bearings; however, I think I want new bearings. You may wonder why I need so many parts. While...

    caklmk 2 Days Ago Go to last post
    caklmk

    Carvings don't center

    For some time my machine places the carvings on my board 1/4" off center. The Carvewright techs tell me to recalibrate my offsets which does nothing to correct the problem as the boards are measured...

    caklmk 2 Days Ago Go to last post