• Recent Forum Posts

    rnichols

    I very rarely use feather so I'm surprise I did...

    I very rarely use feather so I'm surprise I did not check it. Still it turn out great and accomplish what I wanted. I too have watch that video in the past but again I did not think of it. The...

    rnichols 3 Minutes Ago Go to last post
    dbemus

    rnichols, I think the step up resulted because...

    rnichols,

    I think the step up resulted because on the mpc, I did not turn the floor feather and feather off on each region. Picked that up by reviewing one of the tutorials on the CarveWright...

    dbemus 16 Hours Ago Go to last post
    dbemus

    rnichols I believe the step up is a fault in...

    rnichols

    I believe the step up is a fault in the layout of the mpc, I will go back and check and make the correction if necessary. I think I did not set the edges to "0". Glad to see your...

    dbemus 17 Hours Ago Go to last post
    DickB

    Thanks. I haven't kept accurate track of time. ...

    Thanks. I haven't kept accurate track of time. The front fenders weer done in 4 pieces, about 3 hours for three and an hour for one. Similar for the rear. Hood in 4 sections, 2-3 hours each. Rear...

    DickB 17 Hours Ago Go to last post
    rnichols

    Thanks to......

    dbenus and bergerud for their help. Not completly finished yet but getting there. My first question is what would cause the step-up? I went ahead and used it with the ridge on the bottom. again...

    rnichols 18 Hours Ago Go to last post