Hi, Thank you, that is what I needed to know, I will note the changes. I really appreciate your help. Thank you Lori
http://support.carvewright.com/edge-detection-failure-message/
The board sensor is faulting out when trying to find the end or edges of the board.
Lori, The default bit for pattern type carvings like you have set up is always the 1/16" tapered ball nose carving bit. It can be seen in the "board settings"/"Pattern bit" settings. If a new...
Hi, I've been a long time user but not for the past few years. I just completed a project about 4 weeks ago and it went well except it chewed up the sand paper belts at the end. So I...
Recent Forum Posts
Hi, Thank you, that is what I needed to know, I...
Hi,
Loriblackdog 20 Hours AgoThank you, that is what I needed to know, I will note the changes. I really appreciate your help. Thank you
Lori