• Recent Forum Posts

    Deolman

    Angle help

    OK, this is driving me crazy. If someone could help me out, I would greatly appreciate it. Please do not just fix it for me because I need to make several of these with different dimension....

    Deolman 3 Hours Ago Go to last post
    fwharris

    The picture is a bit fuzzy for me to see it...

    The picture is a bit fuzzy for me to see it good.. The most common place that the cable will break is right at the black support bracket and most times it is hard to see with out magnification or...

    fwharris 8 Hours Ago Go to last post
    cjones

    I checked the FFC cable and it appears to be OK. ...

    I checked the FFC cable and it appears to be OK. See pictures. I did notice on the board on the Z-Motor there is a burn mark by one of the other cable connectors. If you look at the one picture,...

    cjones 9 Hours Ago Go to last post
    fwharris

    Look at the ffc ribbon cable, it could be...

    Look at the ffc ribbon cable, it could be torn/cracked. This was similar to the Z stalls I was getting and got the recommendation to get the a907 upgrade.

    fwharris 10 Hours Ago Go to last post
    cjones

    Getting Err E06-0324 again

    Had this error awhile back but was able to get past it somehow. I haven't carved in about 11 months so the machine has been sitting idle but now I am wanting to get back at it. I have a couple...

    cjones 11 Hours Ago Go to last post