FYI for those that might find themselves stuck in the Scan mode - press 0-5-3 on the keypad.
That Error came up when we changed from the 18 pin FFC Cable to the 14 pin Cable and changed the circuit board on both ends.
I got the same error and the z truck would not move very far. thought oh no motor failure. turned out to be a small piece of wood had got between the belt and pulley on the z truck cleaned it relubed...
Glad you got it corrected. Hard to say why it got reset.
Thanks very much for the help! I still do not know how I got to the place I was in the menu.
Since 2001, CarveWright has held an Annual Conference. It is usually mid-June and held south of our facility near Houston
Recent Forum Posts
Recent Articles
FYI for those that might find themselves stuck in...
FYI for those that might find themselves stuck in the Scan mode - press 0-5-3 on the keypad.
lynnfrwd 1 Day Ago