Raven carver stops before completing compiled task. - Troubleshooting

RE: Raven carver stops before completing compiled task.

kennygohar — Mon, 01 Dec 2025 07:43:43 +0000

It sounds like your Raven carver might be encountering a software or communication glitch. A few things you could try: first, make sure your firmware and software are fully updated, as older versions sometimes cause the motor to stall. Also, check all cable connections for any loose or damaged wires. Some users have found that resetting the carver and recalibrating the axes before starting a project helps prevent it from stopping mid-task. If the problem persists, contacting CarveWright support might be the safest route, as they can provide troubleshooting specific to your model.

RE: Raven carver stops before completing compiled task.

cepik — Tue, 15 Jul 2025 21:00:33 +0000

Hi there!

RE: Raven carver stops before completing compiled task.

Joe Lovchik — Wed, 18 Jun 2025 22:46:09 +0000

Did you contact support@carvewright.com? This is something I'm certain they have an answer for. Sounds like a possible signal loss from maybe a faulty USB.

Raven carver stops before completing compiled task.

Anonymous — Sat, 14 Jun 2025 22:57:35 +0000

The cut motor will continue to run but it does not move left, right, up or down. It just continues running, I have to shut off the power, turn on the power, reload the software and start from the beginning.