The cut motor will continue to run but it does not move left, right, up or down. It just continues running, I have to shut off the power, turn on the power, reload the software and start from the beginning.
Notifications
Clear all
Troubleshooting
4
Posts
6
Users
0
Reactions
2,576
Views
Jun 14, 2025 10:57 pm
3 Replies
Jun 18, 2025 10:46 pm
Did you contact support@carvewright.com? This is something I'm certain they have an answer for. Sounds like a possible signal loss from maybe a faulty USB.
Jul 15, 2025 9:00 pm
Hi there!
Dec 01, 2025 7:43 am
It sounds like your Raven carver might be encountering a software or communication glitch. A few things you could try: first, make sure your firmware and software are fully updated, as older versions sometimes cause the motor to stall. Also, check all cable connections for any loose or damaged wires. Some users have found that resetting the carver and recalibrating the axes before starting a project helps prevent it from stopping mid-task. If the problem persists, contacting CarveWright support might be the safest route, as they can provide troubleshooting specific to your model.
