Woodnutt
01-08-2009, 05:23 PM
I purchased a probe and I have a refub CC and there is no connection on the carving truck (QC?) so it says I need a cable to plug into the side of the machine, where do I get said cable from?
Also, the softeware that came with it says Carvewright Project Designer but is suppose the Project Editor. Is the project editor software incorporated in the project designer software and I just need to register the probe to activate it? I think that is what I gathered from another post but want to make sure.
Thanks,
James
Also, the softeware that came with it says Carvewright Project Designer but is suppose the Project Editor. Is the project editor software incorporated in the project designer software and I just need to register the probe to activate it? I think that is what I gathered from another post but want to make sure.
Thanks,
James