Bug in software

[oldjoe]

Not sure this is what Jeff is looking for but I always get a message board to thick to cut though after I load my 60deg bit. I am not doing any cut outs and the board is usually 1/2" thick. I ignore it but maybe it is something to look into.
Also CCM error message comes up right before it starts carving. Never had the message before upgrading to 1.13 also different RPMs in cut motor.
And Thanks Jeff for starting this thread.

[Jeff_Birt]

Excellent! Thanks oldjoe. The error message is indeed a bug, the software guys have that one ironed out in the upcoming 1.132 release. The changing motor speed was done on purpose to reduce wear on the cut motor.

[Digitalwoodshop]

Wow, I like Jeff's web site..... I should start one for CarveWright Repair Advice.... Or just add my pay pal to my tag line.... digitalwoodshop@aol.com ... Snicker..... Better than selling a laser to pay the bills.

AL

[Old Salt]

I down loaded new update

today I imported new jepeg file to patterns and tride to open it up to run in desiner . Micro soft shut me down Sreen said digital product id Internet protool ip adress wrong ?
shut me down every time tride ot open up pattern.

Gary