View Full Version : Brain Fade
James RS
01-03-2009, 11:32 AM
Question on the flip cut, does that cut outside of the line when applied or does it make the part smaller. One of those days
Thank you,
Jim
DocWheeler
01-03-2009, 11:48 AM
Jim,
Since you can flip it back and forth, I find it simpler to just enlarge the view in Designer so that I can see which side of the line it is cutting on. However, I think the default is to cut out the inside of the figure, so flipping would have it go outside.
bjbethke
01-03-2009, 11:49 AM
Question on the flip cut, does that cut outside of the line when applied or does it make the part smaller. One of those days
Thank you,
Jim
It depends on how you originally set up the cut out, that button just flips it one way or the other.
If you have lots of cut paths you can change any one with out affecting the others.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.