View Full Version : Trying To Carve
James RS
12-22-2008, 04:26 PM
Ok I have an idea ( smell the smoke) I want to carve a piece that has a I guess you'd call it a concave part that resembles the wing on the batman logo. Is there a way to do this?
Thanks,
Jim
Kenm810
12-22-2008, 05:34 PM
Jim,
Check out this Thread
Looking for Batman (http://forum.carvewright.com/showthread.php?t=9611&highlight=BatMan)
James RS
12-22-2008, 05:51 PM
Ken yes similar to that, I want to carve the area on the bottom edge of the wing where it slopes upward and around.
Thanks,
Jim
Kenm810
12-22-2008, 06:49 PM
I'm only guessing here, how much of the wing you want.
James RS
12-23-2008, 03:35 AM
I found a picture of the wing part I want to do
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.