corian relief

[carrothers]

I just finished carving out a .25 inch cornian of a boat's silouetee in relief. It came out perfectly except for the "border". The bottom and right side are beveled nicely; but the left side and top just got a slight indentation which gradually peters out on the top. Is this something that I can fix with the software; as I don't it has anything to do with the boat picture that I scanned in which didn't have any border. I tried to attach the mpc file but it was too large and I hate to mess with it to make it smaller. Thanks.

[want2b]

If you can provide a copy of your MPC it will help and a picture of the result would be a great help also. I'm probably not the one to give you an answer but those who can will need that info.
Rick h.

[pkunk]

Try Zipping the MPC.

[carrothers]

unfortunatley the mpc file is slightly over the limit that the formum allows. I can attach it to a direct email if there is somebody out there that wouldn't mind taking a look at the mpc file. I also tried attaching a jpg picture but that was rejected as well. thanks.