View Full Version : need ron justice email
supershingler
12-14-2008, 08:41 PM
does anyone have a current e-mail for ron justice
i need to order some wrenched to change my qc that
i managed to mangle tonight.
i hope to be up and runnimg by the weekend if possible
i got some commitments for christmas
thanks
kendall
Kenm810
12-14-2008, 08:59 PM
Here's a Quote form Ron
rjustice contact info
Hi Guys... The website isnt quite ready to go yet, and is still under construction. If you need info please continue to still email me at the address below.. note that there is an underscore between cw and parts "cw_parts"
Thanks again for your interest!
Ron
__________________
For a current list of custom tools and accessories I make for your CarveWright, send an email request to CW_Parts@yahoo.com (CW_Parts@yahoo.com)
Hope it Helps
pkunk
12-14-2008, 09:46 PM
Just grab an old open end (I forget the size) and grind it down on a bench grinder. If you need the size (don't have a caliper) PM me & I'll measure it.
jcorder
12-14-2008, 09:51 PM
I found that the wrench for my bench router was so close to the one on the cw nut that it worked just fine. If you have one, you might give that a try.
good luck
Jeff
supershingler
12-14-2008, 10:08 PM
just a word of wisdom from the expeirenced
i wasnt checking my allen nuts on my bits and one came loose and trashed my qc.
so slow down when loading bits and check the allen screws.
and by the way how big is the square end bit need to beti replace the qc?
kendall
MikeMcCoy
12-15-2008, 06:12 AM
does anyone have a current e-mail for ron justice
i need to order some wrenched to change my qc that
i managed to mangle tonight.
i hope to be up and runnimg by the weekend if possible
i got some commitments for christmas
thanks
kendall
Hey Kendall - Ron's email address is in Ken's post just below yours.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.