jerrbitt
12-11-2008, 09:36 AM
Any way of testing to check whether the cut motor is spinning at the correct speed? (The rpm sensor checks out okay -- it is counting.)
Had a problem the other day -- y stall error 238 -- and found that the tension on the Y belt had slipped. Tightened that and appeared to solve the Y error problem.
Maybe it's my imagingation but I swear the carving I've got going on right now, is at a lesser speed.
Had a problem the other day -- y stall error 238 -- and found that the tension on the Y belt had slipped. Tightened that and appeared to solve the Y error problem.
Maybe it's my imagingation but I swear the carving I've got going on right now, is at a lesser speed.