y Axis Stall 238

[jtsvstar1100]

Hi guys Just started using my new CW
I did the apple project. Turned out 1/2 right, but that might
be my programing. Went to start another project and I get Y axis stall 238
head is to the keypad side, says homing, then above error.
Any suggestions.

Thx Jeff

[DocWheeler]

Jeff,

Welcome to the forum.
Please introduce yourself to the Search feature, enter "error 238" (including the quotes.

[Rocky]

Hi guys Just started using my new CW
I did the apple project. Turned out 1/2 right, but that might
be my programing. Went to start another project and I get Y axis stall 238
head is to the keypad side, says homing, then above error.
Any suggestions.

Thx Jeff

Recently, I got the same error message. Even though the error referred to the y-axis, it was actually a problem with the z-axis. Are you able to easily move the truck on both of these axis's? My problem was a "jam" on the z-axis and it wouldn't easily move up and down.

Good luck.