My first carve

[MetroGnome]

This was actually requested in the Troubleshooting section but it didn't seem like trouble shooting any more. As you can see its very simple. I first placed a rectangle, and cut it 3/4 of an inch deep. I applied a Horizontal dome surface and set its height to 800. I then added the first names for my wife and I and our 2 greyhounds, sizing it to fill one half of the rectangle and then our last name filling the other side. I added the two leaves after I found a suitable piece of scrap and thought I'd fill up the unused space.

[supershingler]

looks like your off and running

you will be losing sleep like the rest of us carvaholics laying in bed thinking what the next carve will be

great job and good luck on future carves

[Tom75]

good job . that is realy nice