View Full Version : cut out tool
carrothers
11-02-2008, 12:22 PM
I have a .5 depth piece on a carrier board that also measures .5; so when I'm working in Designer I put in the 1.0 measurement for depth. After I finish my design, I want to put an oval around it and have it cut out. I can't find any where on the cut tool tab where you choose the depth of the board? Do I go back and put .5 in the original measurements for the board. Thanks for any advice.
Kenm810
11-02-2008, 01:05 PM
Yes,put the actual board size into designer, if you leave it at 1" the machine will give an error or
try to cut throught the project board and the carrier.
Page 4 and 5
“Select Cut Through Depth”
1) Project
2) Board
You will select
Project (press 1) because you want the
machine to know that the cutouts are on a 1/4” thick
board just like was specified in the project file (mpc
file). Anytime you select the other option (Board) the
machine will ignore the thickness you specified for the
board and base it’s cut depth on the measurement of
the board thickness you put in the machine.
Since this project requires a carrier board to put the
1/4” thin stock on, you do NOT want the machine to
combine the thickness of the board and the carrier
board because it will cut all the way through both! Of
course, that’s NOT what you want!
CarveWright TiPS & TRiCKS - SEPTEMBER 2008
carrothers
11-03-2008, 10:50 PM
thanks for the help...will try it tommorrow.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.