RobertG
10-27-2008, 05:47 PM
Did proper searches on the forums, and didn't find anything that addresses this question.
In Designer I can select the Line Segment Tool and place a straight line on the board. I chose the 1/8 straight bit to do the carving. And I chose the depth to be 1/8 inch deep. I simply want to inlay boarders on a sign.
However
What I hoped to do was to tell the program to make the line 1/4 inch wide.
IF this is doable, how can I persuade the software to persuade the hardware to cut a line 1/4 inch wide by 1/8 inch deep?
IF there is no provision in the software to do this, Why not?
Yes, this can be done by hand routering, but I would have thought that something as simple as this would be covered in the software.
Thanks for any help.
RobertG
In Designer I can select the Line Segment Tool and place a straight line on the board. I chose the 1/8 straight bit to do the carving. And I chose the depth to be 1/8 inch deep. I simply want to inlay boarders on a sign.
However
What I hoped to do was to tell the program to make the line 1/4 inch wide.
IF this is doable, how can I persuade the software to persuade the hardware to cut a line 1/4 inch wide by 1/8 inch deep?
IF there is no provision in the software to do this, Why not?
Yes, this can be done by hand routering, but I would have thought that something as simple as this would be covered in the software.
Thanks for any help.
RobertG