Carvingshark
10-20-2008, 10:54 PM
I am trying to have a countersunk hole (like a forstener bit) overtop of a 1/8" carved hole.
The wider countersunk pattern blots out the deeper hole in the board drawing. I've played with the merge settings with no luck. I have not tested the pattern as yet on the machine.
What's the trick to get this to WSIWYG? (What you see is what you get?)
Thanks
The wider countersunk pattern blots out the deeper hole in the board drawing. I've played with the merge settings with no luck. I have not tested the pattern as yet on the machine.
What's the trick to get this to WSIWYG? (What you see is what you get?)
Thanks