View Full Version : 1.131 cuts old carvings too deep, did I forget to do something
jdudley
10-20-2008, 11:29 AM
I upgraded to 1.131 last Thursday and now some of my carvings that should go .010 to .020 are going about .030 to .040. I formatted my card, saved the old carvings with new names to make sure they were saved with the new version. What else can I do?
Thanks,
Jeff
cnsranch
10-20-2008, 12:12 PM
Your actual board's thickness vs the thickness you entered in Designer now makes a difference. That may be the culprit if your actual board's thicker than Designer's.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.