Amonaug
10-16-2008, 06:21 PM
Was doing a carving and heard the CW stop long before it was suppose to so I went and checked on it. Looked at the LCD screen and saw
"Please reinsert card, press ENTER to continue"
New one to me, all I did was slightly push on the card and it felt well seated so I pressed ENTER, it's now carving again.
EDIT: Just had it do it again. I had the bottom plate off earlier and vaccumed in it, wonder if I loosen a wire. Will have to check it after the carve is done.
"Please reinsert card, press ENTER to continue"
New one to me, all I did was slightly push on the card and it felt well seated so I pressed ENTER, it's now carving again.
EDIT: Just had it do it again. I had the bottom plate off earlier and vaccumed in it, wonder if I loosen a wire. Will have to check it after the carve is done.