Firmware versions and older MPC files

[Lin]

I have two cards. I have 1.126 on one now and 1.131 on the other. I also have some old files one the one with 1.131 on it that were from the software version and firmware version of 1.120. One of these files I don't have saved except on the card....(don't ask...my screw up) anyways...will it carve those older files ok since I upgraded the card to the newer firmware version or no? None of them have cut paths on them.
Lin

[Major_A]

It should work just fine. The firmware is just telling the machine how to operate. Since you have a new firmware (AKA control logic) it will carve the project with the new instructions.