View Full Version : 1.131 upgrade question
supershingler
10-06-2008, 03:39 PM
Ive been reading the tip and techniques on the upgrade but was looking for imput and opinions
i didnt upgrade when everyone was complaining about the 1.130 but would like to now
all opinions welcome
thanks
Kendall
David Myers
10-06-2008, 04:03 PM
I had an issue with the cut path feature (were the bit would cut out a pattern in one pass) but it has been fixed and you can adjust the cut depth per pass also the number of tabs that you want to leave.
I have done 6 carves using 1.131 with no problems (knock on wood), I hope I did not jink myself.
It has other features that I have not used yet.
David
1.131
Amonaug
10-06-2008, 04:14 PM
In my opinion 1.31 is one of the best updates so far.
mtylerfl
10-06-2008, 08:23 PM
I just finished my third project using 1.131 tonight (I'm not counting all the short test carvings I did during the Beta testing). I LOVE the control I have over the cut paths now, with this new version!
TerryT
10-07-2008, 08:10 AM
I have had very good luck so far with 131.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.