Centerline info

[henry1]

Can some one direct me to the info or tutorial for centerline and can you put a designe on the same board and then the machine tell you change bit for intrecat work or you use same bit for all:confused:

[forqnc]

Centerline uses the 90 deg and 60 deg bits only, there depth are determined by the software and it only goes on the board surface. It cannot go on curved surfaces as of now, who knows in the future.
Yes a design can be on the same board with the exception of above, the machine will ask for all the bits at the begining of the carve and then when it requires them during the carve.
Good Luck