View Full Version : Need help, 2 dimension
grjensen
09-24-2008, 05:15 PM
How can I do the attached as shown. i would like to have the finished product exactly like the attachment. No 3D effect.
Kenm810
09-24-2008, 05:45 PM
grjensen,
Welcome to the CW Forum
Is this something like what your looking for?
If you can save it as a PNG file and upload it in to your CW Designer
bjbethke
09-24-2008, 05:58 PM
Not sure if this is what you want. I downloaded your image to Adobe Illustator, changed to a vector file, Exported as a PNG file, removed background. Loaded to CW Designer. made this PTN.
sewpeck
09-25-2008, 07:28 AM
I took your picture, ran it thru sigmac and then centerlined it, and used a 60 v-bit
bjbethke
09-25-2008, 08:42 AM
sewpeck, You need to post the type font to make this work for others. All I get is the letter "a"
grjensen
09-25-2008, 08:51 AM
Not sure if this is what you want. I downloaded your image to Adobe Illustator, changed to a vector file, Exported as a PNG file, removed background. Loaded to CW Designer. made this PTN.
I have finally figured it out. Thanks for your help
grjensen
09-25-2008, 08:52 AM
grjensen,
Welcome to the CW Forum
Is this something like what your looking for?
If you can save it as a PNG file and upload it in to your CW Designer
I finally figured it out. Thank you for your support.
bjbethke
09-25-2008, 09:27 AM
You can also use the V Bits with a PTN. Make a PTN with all the background (white) removed. Load PTN, select Outline, select V bit. Then remove the PTN. Takes less time to carve this way.
The Rose image is in a GIF format, the background is removed.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.