View Full Version : Make scanned object to patern
Wallace Campbell
09-22-2008, 09:14 PM
I am lost, scanned a carving now want to make a pattern don,t know what to do to get this carved
SAA3840
09-22-2008, 10:48 PM
Assuming you've been able to open Pattern Editor, with your card reader plugged into a USB port, you click on download scan in Project Designer. This will open your scan in Pattern Editor.
Check your scan, make sure it's what you want to save then in Pattern Editor click on File, Save to Pattern Library and then save it wherever you want. You can create a new folder to save it in.
Play around with it, you'll get it figured out. Heck, I did!!.
After you've saved your pattern, you can put it on a board in Project Designer and then carve it.
Good Luck
Wallace Campbell
09-23-2008, 08:52 AM
Thanks SAA3840 for your help will try that.
mtylerfl
09-23-2008, 01:13 PM
Thanks SAA3840 for your help will try that.
Couple more things that might be helpful for you as you venture into the "scanning realm" :)...
View the Scanning Probe Video at:
http://www.carvebuddy.com/scanningvideo_how_it_works.html
Read the Tips & Tricks Issue #9, "Scanning Sled Techniques" and the Tips & Tricks Issue #10, "The CarveWright Pattern Editor". Download both free newsletters from: http://www.carvebuddy.com/learning_center.html
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.