SAA3840
09-20-2008, 11:07 PM
I tried to get my machine to cut five 3/4" dados across a board. The machine cut three, no problem. (Only 3 because I stopped it). When the first dado became exposed on the machine, I test fitted a 3/4" board and found that the dado was actually 7/8", as well as the next two that were already done.
I was using the 1/8 carving bit and it made three beautiful dados, they were just 1/8" too wide.
Anyone have a guess as to why? I went ahead and scrapped the board and set up my table saw with the dado blade and made my cuts. I was just wondering why the Carvewright machine couldn't make a 3/4" wide cut.
:confused::confused:
I was using the 1/8 carving bit and it made three beautiful dados, they were just 1/8" too wide.
Anyone have a guess as to why? I went ahead and scrapped the board and set up my table saw with the dado blade and made my cuts. I was just wondering why the Carvewright machine couldn't make a 3/4" wide cut.
:confused::confused: