New 1.31 Software vs 1.26

[undrtkr]

With the new software installed & firmware on the card. I experience the following: 1) Speed-up after running about 5 min 2) Cross cut 3/4 board in one pass & 3) Edge route in one pass. I didn't break anything, but it was nerve wracking. Carving was OK too. If I put firmware 1.26 on a card, will it stop these instances?
Thanks, Tom

[mtylerfl]

Tom,

Just to confirm...what software version are you running?...is it 1.130 or 1.131?

(I think your cut motor speed change was already addressed in a couple of previous postings you had made.)

[badger]

Did I miss something? 1.131?

[atauer]

Gentlemen,

I thank that Tom means 1.130 and is mistaken. 1.131 does not exist.

[cnsranch]

True, but 1.136 is is the best thing since sliced bread.

[Kenm810]

Wow, Take a day off form the CW Forum and get left in the dust!!

Carver Chips and Dust I meant -- http://www.carvewright.com/forum/images/smilies/icon_razz.gif

[cnsranch]

You snooze, you lose - upgrade was only available between 3 am and 3:15 am today :twisted:

[undrtkr]

Sorry, guys, I sent that from work and didn't get the versions correct. Anyway, I will be trying the 1.126 either tonight or tomorrow night. I'll use the same carvings and let you know the results.
Tom

"You don't have to be old to be a . . . "

[badger]

You snooze, you lose - upgrade was only available between 3 am and 3:15 am today :twisted:


Yea but the only problem is, it comes with a little sea water thanks to Ike.