PDA

View Full Version : Plate


rlane10347
09-13-2008, 06:14 PM
This is a wall plate that I turned for a friend. I carved the center then turned the flange on the lathe. The wood is popular.
RanUtah
09-13-2008, 06:21 PM
Now that is very cool! I have a mini lathe, maybe I could make coasters!
AWoodsmith
09-13-2008, 08:14 PM
Very nice, where did you get that pattern?
rlane10347
09-13-2008, 08:43 PM
The pattern is one that I carved then scanned into the CW. I am working on a series of Maine wild life. I make the design out of clay, harden it then scan it in.
AWoodsmith
09-13-2008, 10:04 PM
If you are willing, I would love to buy some from you, unless you are going to share eventually?????:)
rlane10347
09-14-2008, 07:39 AM
I have only been using the CW for 4 months. I took on 2 large wall designs for my neighbor. One wall is done and posted in the customer gallery. The animals I am doing now are for the second wall. I will post a picture of it when done. I was hoping to put some of my work in the pattern store but after several emails I have never heard from them. I will be shareing some in the future but for now I must get the wall finished. Thanks for your interest.
AWoodsmith
09-14-2008, 08:23 AM
Just let me know when you post them, it is much appreciated.


Ed:D