jerrbitt
09-05-2008, 10:54 AM
Replaced the Tracking Assembly after LHR suggested tht was the prblem in the error message ""Bit Depth does not match."
Works better but still have some problems. Sometimes the carving bit starts about an 1/8 above the board and consequently the depth does not corresppond to the pattern depth. Then I run the same pattern again, and this time it goes perfectly. Board is smooth, square, no cups.
This is after the normal setup and I watch carefully making sure the board is measured correctly and the bit plate is touched twice. Today I attempted to carve the same pattern I did yesterday without problem but today after the carving was done, the cut path did not go all the way through. About a 1/16" or so short of a through cut. And during setup, no error messages about bit depth occured.
Any ideas before I call LHR again. Getting frustrated.
Works better but still have some problems. Sometimes the carving bit starts about an 1/8 above the board and consequently the depth does not corresppond to the pattern depth. Then I run the same pattern again, and this time it goes perfectly. Board is smooth, square, no cups.
This is after the normal setup and I watch carefully making sure the board is measured correctly and the bit plate is touched twice. Today I attempted to carve the same pattern I did yesterday without problem but today after the carving was done, the cut path did not go all the way through. About a 1/16" or so short of a through cut. And during setup, no error messages about bit depth occured.
Any ideas before I call LHR again. Getting frustrated.