Cut path

[micboi]

Hi every one,

I'm beginner with the CW. With the cut path, is it possible to make more than one pass to help the end mill ? example : 3 pass of 0.250" for 0.750" material thickness. Thanks in advance for your help !!!:confused:

[mtylerfl]

Hi every one,

I'm beginner with the CW. With the cut path, is it possible to make more than one pass to help the end mill ? example : 3 pass of 0.250" for 0.750" material thickness. Thanks in advance for your help !!!:confused:

Not at the present time...

[Jeff_Birt]

I've found the single pass cutting to work very well. It has done a great job through lots of pine and poplar. Another forum member has posted pictures of guitars he has carved from Maple with the same 1.130 firmware.