Winfieldsjr
09-01-2008, 05:39 PM
When I started up after installing the new Z pack conversion. The carver starts as normal sensing the board depth etc, As soon as it starts"CARVE" the Z axis plunged through the board and stops as the Z axis is maxed out motor stalls.
Now there is no home position sensor on the Z axis.
Any words of wisdom ?
Also I have been afraid to use the probe as its input was on the old circuit board that has no cable connection now as the new PRINTED CIRCUIT BOARD HAS NO INPUT FOR THE SCANER.
Now there is no home position sensor on the Z axis.
Any words of wisdom ?
Also I have been afraid to use the probe as its input was on the old circuit board that has no cable connection now as the new PRINTED CIRCUIT BOARD HAS NO INPUT FOR THE SCANER.