View Full Version : new user
pscychnurse
08-27-2008, 06:20 PM
do i push my board 3 1/2 inches past where i want it to start? The manual sucks
supershingler
08-27-2008, 06:43 PM
if you added 7" (3 1/2 for both ends)
then just load it in the machine and start your carve
it will measure the board and then ask if you want to center on length
say \yes and it will say under the rollers and all should be well
good luck
kendall
pscychnurse
08-27-2008, 06:52 PM
THANKS couldnt find anything in th manual
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.