View Full Version : Zpack Question
badger
08-27-2008, 02:29 PM
Middle of replacement. Not sure what is suppose to happen to this ribbon. It runs through the back of the Y truck and down the center. Didnt see it mentioned in the pdf instructions.
Amonaug
08-27-2008, 02:44 PM
That is the old probe connection which with the new z-pack is now on the cover. You can remove that ribbon.
badger
08-27-2008, 02:49 PM
Thank you Amonaug
badger
08-27-2008, 05:33 PM
Back in action, almost got frustrated when I turned it on and all I received was Scan Area.
Thanks to the search feature found a previous post to reset options to cover for the probe instead of ytruck. After that carving again, so far no more air carving.
Jeff_Birt
08-27-2008, 05:48 PM
Thanks to the search feature ...
Music to my ears :)
fwharris
08-27-2008, 09:46 PM
Badger,
Glad to see you are back in action! And you know why Jeff is glad!
Great job!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.