nissinxx
08-17-2008, 06:56 PM
i have tried this program 3 times now and it screws up every time ....
I;m using 1.126 and the problem is that once it starts cutting the cutter keeps going deeper than it should. i heard some strange noise the fist time.. When I went to check on it it had cut clear threw the board on the s... here is the file i ran any info will be good..
thanks,
I;m using 1.126 and the problem is that once it starts cutting the cutter keeps going deeper than it should. i heard some strange noise the fist time.. When I went to check on it it had cut clear threw the board on the s... here is the file i ran any info will be good..
thanks,