jackssib1
08-13-2008, 07:43 PM
Well 1st. the roller bearing sweeper, went out, I ordered 4 more, good thing.
one of them had no threads, so I installed one in bad spot. after that 2 days later another went bad. so installed another,,lol
That one has worn spot in housing where the old roller rubed. Then the screw that holds
the Flexshaft pivot assembly on came out and the other broke off in housing, drilled out and replaced screw.
Looks like I need a whole overhaul. and so does the carver..lol What next..?
oh well, it will get better.
Thanks
Jack
one of them had no threads, so I installed one in bad spot. after that 2 days later another went bad. so installed another,,lol
That one has worn spot in housing where the old roller rubed. Then the screw that holds
the Flexshaft pivot assembly on came out and the other broke off in housing, drilled out and replaced screw.
Looks like I need a whole overhaul. and so does the carver..lol What next..?
oh well, it will get better.
Thanks
Jack