twinpeaksenterprises, LLC
08-11-2008, 07:19 PM
Okay about every 30 minute carve i get two new errors. But being the optimist that i am... Here we go...
1. Yes i did the search and tried all of those resolutions..
2. Im getting the lid open signal which pretty much shuts down the machine from doing anything.
I checked all the connections and no problem there to speak of. I pulled the switch out and sprayed it with compressed air for what thats worth. So am i looking at needing a new switch? Somebody said there available at radio shack. Also is there a way to jumper the switch just to test and make sure thats not the problem? Also i welcome any suggestions to try anything else... I fixed five errors this week and this is the only one thats got me hung up. Hopefully its just the switch and not something more serious. Thanks in advance. Matt
1. Yes i did the search and tried all of those resolutions..
2. Im getting the lid open signal which pretty much shuts down the machine from doing anything.
I checked all the connections and no problem there to speak of. I pulled the switch out and sprayed it with compressed air for what thats worth. So am i looking at needing a new switch? Somebody said there available at radio shack. Also is there a way to jumper the switch just to test and make sure thats not the problem? Also i welcome any suggestions to try anything else... I fixed five errors this week and this is the only one thats got me hung up. Hopefully its just the switch and not something more serious. Thanks in advance. Matt